Performance Meters & Lap Timers
Accessories
-
Replacement battery for VBOX Sport (and Video VBOX Lite). -
This is the lower part of the RLACS286 Roll Cage Mount. It includes the curved mounting bracket, two jubilee clips, four worm drive hose clips and a protective sheet. The elbow joint that screws directly into a Video VBOX camera is not included. The clips are sufficient diameter so that these mounts can be used on an FIA specification roll cage. -
HDMI cable for use with VBOX Video HD2. HDMI male to HDMI male, 2 m. -
Protective lens cover for an HD2 1080p camera. -
Start/stop logging switch for Video VBOX with a cable length of 2 m. Please choose between the following options: -
With its quick-release catches, the mounting bracket allows for the VBOX Video HD2 to be secured in the car but also quickly removed. -
This GNSS (GPS/GLONASS/Galileo) antenna with RG-174 & SMA connector and 3 m cable is IP67 rated and suitable for the following products: - VBOX Video HD2 - VBOX Touch - Mini Lap Timer - Mini Pit Lap Timer - 25 Hz VBOX Lap Timer (black front panel)* - 25 Hz VBOX Pit Lane Timer (black front panel)* -
If you're struggling to get the forward-facing camera in the right position to allow for a good view of the track, this extension bar should help. -
Our miniature OLED display can show a wide range of parameters, including live and max speed, lap times, and predictive lap timing. It is readable in bright sunlight, has an IP65 waterproof aluminium housing and additional LEDs to indicate your speed relative to your fastest lap. A video logger is required to operate, and can be connected via the 2 m flying lead. -
This harness bar mount for 1 5/8" (41.275 mm) roll cages is compatible with both HDMI and non-HDMI VBOX Video HD2 systems. -
Unterminated CAN Interface Cable for Video VBOX and VBOX Video HD2 that allows for bare wire connection to the CAN High and CAN Low wires in a vehicle's wiring loom. -
The roll cage mount has a solid aluminium body, connected to a curved mounting plate that is bolted to the bar via a pair of jubilee clips (2 supplied) or worm drive hose clips (four supplied). The clips are sufficient diameter so that these mounts can be used on an FIA specification roll cage. The kit also contains a strip of protective rubber to stop the roll bar from being scratched. NEW: A locking nut has been added to facilitate the fastening of the camera/display.
