Performance Meters & Lap Timers
Accessories
-
The VBOX CAN Gateway allows logging of vehicle CAN bus data in a VBOX system where secondary CAN modules such as the OLED display or analogue input modules are used. -
6-PIN Mini DIN to 9-PIN D-Type CAN interface cable (1m) for use with Video VBOX Lite. -
Wired remote start/stop USB logging switch for VBOX Video HD2. -
Our miniature OLED display can show a wide range of parameters, including live and max speed, lap times, and predictive lap timing. It is readable in bright sunlight, has an IP65 waterproof aluminium housing and additional LEDs to indicate your speed relative to your fastest lap. A video logger is required to operate, and can be connected via the 2 m flying lead. -
2 m power cable for connection to an in-car 12V auxiliary or cigar lighter socket. -
HD2 mono microphone with LEMO plug. -
Unterminated CAN Interface Cable for Video VBOX and VBOX Video HD2 that allows for bare wire connection to the CAN High and CAN Low wires in a vehicle's wiring loom. -
Protective lens cover for an HD2 1080p camera. -
This camera clamp is designed specifically for a VBOX Video HD2 camera, ensuring that the camera remains intact even when fully tightened. It is made of aluminium with a rubber liner to safeguard the camera and is tightened using two M3 hex-socket screws (2.5 mm Allen key required). The clamp can be attached to either the Roll Cage Camera Mount (RLACS286) or the Suction Camera Mount (RLACS287) and provides a secure mounting option for the camera. -
The roll cage mount has a solid aluminium body, connected to a curved mounting plate that is bolted to the bar via a pair of jubilee clips (2 supplied) or worm drive hose clips (four supplied). The clips are sufficient diameter so that these mounts can be used on an FIA specification roll cage. The kit also contains a strip of protective rubber to stop the roll bar from being scratched. NEW: A locking nut has been added to facilitate the fastening of the camera/display. -
3 m extension cable for the Video VBOX Lite cameras. -
The camera clamp for Video VBOX cameras only (will not fit a VBOX HD2 camera) connects to a VBOX suction or roll cage mount and allows for greater articulation of the cameras. This is especially useful if the cameras need dropping far enough to gain a good view through the windscreen.
